Materials

Our high tech cutting machines are able to cut many different types of material. If you are unsure about a material, do not hesitate to contact us and ask if we can meet your requirement. Just about every time our answer will be yes.

We stock on site a variety of materials for your use; we can also source most materials you may require for your job. If you would prefer to supply your own, you are more than welcome to do so (please note however that mild steel must be clean, rust and scale free and the sheet must be flat to achieve satisfactory laser cutting results).

The table below indicates our capacity for some of the more common materials we cut.


Laser Cutting - Sheet

  • One offs and large production runs
  • Clean square cut edges requiring little or no clean up
  • Bed size 3.0m x 1.5m
Steel Thickness Range (mm)
Mild Steel Up to 16mm
Stainless Up to 16mm
Aluminium Up to 6mm
Galv Sheet Up to 3mm
   
Wood Thickness Range (mm)
MDF Up to 30mm
Plywood Up to 30mm
Pine Up to 30mm
Particle Board Up to 30mm
   
Plastic Thickness Range (mm)
Acrylic Up to 20mm
Polypropelene Up to 12mm
Polycarbonate Up to 6mm
Polyethylene Up to 12mm

Maximum sheet size : 3.00 x 1.50 meters

Sheet Laser Cutting

Laser Cutting - Tube

  • One offs and large production runs
  • Clean square cut edges requiring little or no clean up
  • Maximum feed length 8m

MATERIALS Stainless Steel and Steel


Chuckable Diameter
  • Round:    Ø19mm – Ø220mm
  • Square:    19mm – 150mm
  • Channels:    19mm – 150mm
  • Angles:    19mm – 150m
Diameter through chuck Ø19mm to Ø220mm
Maximum Pipe Mass 200kg
Tube Laser Cutting

Plate or Gas Cutting

  • Very economical method of material cutting
  • Ideal for structural steel plates, building brackets, welded and galvanised components that need to be machined after cutting
  • One offs and large production runs
  • Bed size 3.6m x 12m
Steel Thickness Range (mm)
Mild Steel Up to 100mm
Stainless Up to 25mm
Aluminium Up to 12mm

Maximum sheet size : 3.60 x 12 meters


Water Cutting

  • No heat affected zone therefore no heat distortion or hardening of material.
  • One offs and large production runs
  • Clean square cut edges requiring little or no clean up
  • Bed size 3.6m x 1.8m
Steel Thickness Range (mm)
Mild Steel Up to 50mm
Stainless Up to 50mm
Aluminium Up to 40mm
   
Wood Thickness Range (mm)
  Up to 100mm

Many other materials can be Water cut including Tiles (flooring & wall), Glass, Brass, Copper& Titanium. Other materials may also be Water Cut please don't hesitate to contact us and ask. We can supply or source some materials or you can supply your own.

Maximum sheet size : 3.60 x 1.80 meters


Please enquire if you are unsure as to whether a material is able to be etched. It is most likely possible.

For further information, do not hesitate to contact us.